Cart Now in your cart 0 items. This product is an Online Exclusive. Get the bolt too loose and the cap will hold a pullout load about as well as bubble gum on the end of a nail. We tried to set the bolts by "feel," just as you would when climbing. Noon Home Smart Switch. Showing inventory for stores near:
Anchors - Hangers, Strut & Fasteners - Ferguson
Oct 25, Messages: Drill hole to any depth exceeding the desired embedment. There are two important facts that must be taken into consideration with respect to deeper embedment depths. Trubolt Wedge anchors feature a stainless steel expansion clip, threaded stud body, nut and washer. These usually cure much faster, but tend to hold a less. Clean the hole of all dust using a wire brush, vacuum or compressed air. Not too worried about the sleepers since they will have several anchors and I will be glueing them to the concrete as well.
The problem is that the engineer did his inspection after the sill was installed and notes a lot of assumptions in his letter. The Dynabolt Sleeve anchor works well in hollow materials like brick and block. A vise typically has a lot of hard stresses put on them due to its uses, so it would not take long for lead anchors to work loose. If you would like to have improved access to the forum please upgrade to Sawhorse by clicking here: If that's the type you have, you might could be able to do that, and put in a shorter bolt, or epoxy some allthread in.